Tiger JD6 E Series, Mounting And Operating Instructions

Page: 133 / 244

MAINTENANCE
Boom Maintenance Section 4-31
©2015 Alamo Group Inc.
MAINTENANCE
DAILY MAINTENANCE SCHEDULE
The following services should be performed daily or every 8 hours of service, following the detailed
maintenance instructions in the operator’s manual.
_______ Pump driveshaft: If required with drive shaft/coupler check for end play and lubricate at zerks.
_______ Crankshaft adapter: If equipped with rubber grommets check condition, replace if missing or
damaged.
_______ Pivot points: Inject grease until it appears at ends.
_______ Hydraulic fittings: Check for leaks with paper or cardboard. Tighten fittings or replace hoses
immediately.
_______ Knives: Inspect for missing or damaged knives, change (only complete sets) as needed.
_______ Belts: Check/tighten/replace belts as needed.
_______ Mainframe/deck: Unless otherwise specified retorque bolts according to torque specifications in this
section.
_______ Hydraulic fluid level: Add, if required, per fluid recommendations.
_______ Rear flail drive, bearing flange and shaft couplers: Grease as instructed in the detailed maintenance
section.
_______ Cuttershaft and ground roller: Grease as instructed in the detailed maintenance section.
Service performed by:_______ Date:____/____/____ Hour
Meter:________
Maintenance Section
**This page may be copied and used as part of the daily maintenance routine.