Tiger JD6 E Series, Mounting And Operating Instructions

Page: 106 / 244

MAINTENANCE
Boom Maintenance Section 4-4
©2015 Alamo Group Inc.
MAINTENANCE
Regular Maintenance
The intervals at which regular servicing should be done are based on hours of operation. Use the tractors hour
meter to determine when regular servicing is required.
Refer to the Detailed Maintenance section for futher instructions on greasing. Copy and use the Daily
Maintenance sheet located at the end of this section.
Daily or Every 8 Hours
ITEM SERVICE COMMENTS
Drive Shaft Yoke, U-Joint Grease Grease as instructed in
& Stub Shaft detailed maintenance section
Pump Drive Shaft Coupler Check and Lube Insure driveshaft end play
Crankshaft Adapter Check rubber grommets Replace grommets if
damaged or missing
Pivot Points Lubricate Inject grease until it
appears at end
Hydraulic Fittings Check for leaks Tighten when needed. Do Not use hands
to check for leaks, see maint. precautions
Knives Check Inspect for missing or damaged knives,
change as needed.
Spindle mouting bolts Check Torque to 315 ft. lbs. lubricated
spindle to deck) Torque to 357 ft. lbs. dry
Knife mounting bolts Check Pre-lubricate threads with anti-seize
(knife to disk or blade bar) torque to 800 ft. lbs.
Disk/Blade Bar mounting bolts Check Torque to 180 ft. lbs. lubricated
(disk/blade bar to spindle) Torque to 204 ft. lbs. dry
Belts Check/Adjust Check if broken, tighten as required
Main Frame and Check Retorque bolts to torque
Deck specifications in this section
Hydraulic Fluid Level Check Add if required per fluid recommendations
Rear Flail Drive(if applicable) Lubricate Grease as instructed in
Bear Flange and Shaft Coupler detailed maintenance section
Cutter Shaft and Lubricate Grease as instructed in