TiePie Handyscope HS5 series, User Manual

Page: 36 / 47

Pin 8, Power OUT, has the same potential as the Handyscope
HS5 power supply. When the Handyscope HS5 is USB powered,
it is at USB power level. When the Handyscope HS5 is externally
powered, it is at the same level as the external power input.
8.4 AUX I/O
The Handyscope HS5 has two Auxiliary I/O connectors at the rear
of the instrument. These can be used to combine multiple instru-
ments to a single combined instrument to perform synchronized
measurements.
Figure 8.6: Auxiliary I/O connector
Pin Description Pin Description
1 GND 11 Data OK P EXT (LVDS)
2 EXT CLK P (LVDS) 12 Data OK N EXT (LVDS)
3 EXT CLK N (LVDS) 13 reserved
4 GND 14 Generator Trigger (I/O)
5 Data OK (I/O) 15 reserved
6 reserved 16 reserved
7 GND 17 GND
8 Ext Trigger (I/O) 18 reserved
9 reserved 19 GND
10 GND
Table 8.3: Pin description Auxiliary I/O connector
The I/O signals (pins 5, 8 and 14) can be used as input and
output. They are digital signals switching between 0 V and 2.5 V.
The LVDS external clock (pins 2 and 3) must be 10 MHz,
±
1%.
The Auxiliary I/O connectors use HDMI type C sockets, but
are not HDMI compliant. They can not be used to connect
an HDMI device to the Handyscope HS5.
32
Chapter 8