ATTENTION!
Measuring directly on the
line voltage
can be very dangerous.
The
outside
of the
BNC connectors
at the Handyscope HS5 are
connected with the
ground
of the computer. Use a good isolation
transformer or a differential probe when measuring at the
line volt-
age
or at
grounded power supplies
! A short-circuit current will
flow if the
ground
of the Handyscope HS5 is connected to a positive
voltage. This short-circuit current can damage both the Handyscope
HS5 and the computer.
Copyright c
2016 TiePie engineering.
All rights reserved.
Revision 2.14, January 2016
Despite the care taken for the compilation of this
user manual, TiePie engineering can not be held
responsible for any damage resulting from errors
that may appear in this manual.
Summary of Contents for Handyscope HS5 series
