![Ti Lite Aero R Owner'S Manual Download Page 76](http://html.mh-extra.com/html/ti-lite/aero-r/aero-r_owners-manual_1114045076.webp)
10-1
Aero R Owners Manual
OM_R_0809RevB
CHAPTER 10: WHEEL LOCKS
I
WARNING
TiLite recommends that you remove the wheel locks from your chair frame prior to engaging in any contact sport.
If
you ignore this Warning, you may seriously injure yourself or others or damage the wheelchair.
I
WARNING
The wheel stop must embed at least 3/16” into the tire or the chair may roll unexpectedly. Therefore, before adjusting
the lock you must make inflate the tires to the recommended tire pressure (see sidewall of the tire). If you adjust the
locks when the tires are under-inflated, the lock will not operate properly when the tire is fully inflated.
If you ignore
this Warning, you may fall, tip over or lose control of the wheelchair and seriously injure yourself or others or damage
the wheelchair.
I
WARNING
After adjusting the wheel locks, engage the wheel locks and push against the tires to verify that the wheel locks
prevent the wheels from moving. If not, readjust the wheel locks until the wheel locks securely prevent the chair from
rolling.
If you ignore this Warning, you may fall, tip over or lose control of the wheelchair and seriously injure yourself
or others or damage the wheelchair.
Standard Push to Lock
Adjusting the Push to Lock Wheel Lock
Tools Needed:
• 3/16” Allen Wrench
1. Loosen the Allen Screws in the wheel lock clamp. See Figure 10-1.
2. Adjust the position of the wheel lock clamp on the frame so the wheel stop embeds at least 3/16” into the tire
when engaged in the locked position.
3. Securely tighten the two Allen Screws that secure the wheel lock clamp to the frame.
Figure 10-1
Adjusting/Relacing Push to Lock Wheel Lock
Allen
Screws
Wheel Lock
Clamp
Wheel Stop
Frame
Tire
Replacing the Push to Lock Wheel Lock
Tools Needed:
• 3/16” Allen Wrench
1. Loosen the two Allen Screws that secure the wheel lock clamp to the frame. See Figure 10-1.
2. Slide the wheel lock out of the clamp.
3. Slide the new wheel lock into the wheel lock clamp, but do not tighten the Allen Screws.
4. Follow the procedures under “Adjusting the Push to Lock Wheel Lock” on page 10-1 to position and secure the
new wheel lock.
Summary of Contents for Aero R
