-11-
1. Use a color tape at the tip of main blades for tracking identification easily.
2. Increase the main blade speed for slight lift-off.
3. Observe which blade appears to be lower than the other, and increase the
pitch of the lower blade for one turn of the Linkage Rod at a time until
each blade runs in track. If both main blades rotate in the same path, it
doesn
,
t need to be adjusted.
1. 在主旋翼前端貼上色標可方便辨識軌跡。
2. 提高主旋翼轉速使機體稍懸浮於地面。
3. 觀察兩支旋翼軌跡是否有落差（雙槳），調整軌跡較低旋翼上的連桿長度，一次
調整一圈，直至兩支旋翼軌跡一致。若軌跡一致則無需調整。
Linkage Rod
連桿
BLADE TRACKING ADJUSTMENT
主旋翼軌跡調整
Out of track will cause vibration, instability and a loss of power due to additional drag. Please adjust the tracking repeatedly until
the blades are in track properly.
旋翼軌跡落差（雙槳）會造成直昇機震動、不平衡及損失動力。請務必進行調整以使旋翼軌跡精準正確。
Congratulates all the setting for your helicopter have been done and ready to fly right now. It is strongly recommended
to seek helps and guidance from accomplished pilots if you were a newcomer to the RC helicopters!
恭禧您已完成直昇機所有設定並可準備起飛。如果您是剛接觸模型直昇機的初學者，我們強烈建議您尋求有經驗的玩家給予協助及
指導！
color tape / 色標貼
Out of Track
/ 雙槳
Adjustment is
necessary.
需要調整
color tape / 色標貼
In Track
/ 軌跡正確
Adjustment is
unnecessary.
不需要調整
For safety, ensure to keep a safe distance from the helicopter at least 5 meter (15 feet) while making tracking adjustment.
安全起見，進行主旋翼軌跡調整時，請至少與直昇機保持5米（15呎）的安全距離。
CAUTION /
警告
CAUTION /
警告
