-7-
The movement direction of servo may differ in different brand of radio system; Power on your transmitter and receiver, please refer
the figure below to ensure the direction of swahplate and servo movement are correct, as well as observe if there is any bind or
interference when the servo reaches to the maximum travel point.
各品牌遙控系統伺服機方向訊號或有不同，請依序開啟發射機及接收機，參閱以下圖示確認十字盤及伺服機作動方向正確，同時觀察伺服機作動達最
大行程量時，是否有行程量過大或干涉情況。
Before starting, ensure the following preparation is done.
1. Set all trims, knobs and switches to the neutral position.
2. Reset the radio to its factory preset position.
3. Choose the “Normal (non-mixing)”swashplate control mode.
The control system of E325S is a 120° CCPM, but please set the swashplate control mode on you
transmitter in “Normal (non-mixing)”since the mixing function is leaded by the GT5.1 flybarless control
system which comes with the E325S ARF.
設定發射機前，請確認以下注意事項：
1. 發射機上所有調整旋鈕、機構均位於中立點
2. 恢復設定值為原廠內建數據
3. 十字盤模式請選用“Normal (無混控)”模式
E325S的控制系統為120度CCPM模式，但因為混控功能將由E325S附機上的GT5.1無平衡翼控制系統主導，因此請
將遙控器上的控制模式設為“Normal (無混控)”。
For safety, to set a Fail Safe function per your transmitter instruction manual at this step as well is strongly recommended.
安全起來，建議您參閱遙控器說明書，在此步驟中同時設定“安全回復”功能。
If the movements of servos or swashplate are incorrect, please refer your transmitter manual to turn on the
“
Servo Reverse
”
function
for one or more channels in your transmitter.
If there
’
s
any bind or interference when reaching the maximum servo travel point, please also refer your transmitter manual to reduce
the
“
Travel Adjustment (or End Point Adjustment)
”
value in your transmitter.
如伺服機或十字盤動作方向錯誤，請參閱您的遙控器說明書，開啟遙控器上的伺服機逆轉功能。
如伺服機最大行程量過大或發生干涉，請參閱您的遙控器說明書，降低伺服機行程量設定值。
Mode 1
Mode 2
Servo Horn movement
伺服機擺臂動作
Check Point
機構動作確認
Aileron
副翼
Elevator
升降舵
Pitch
螺距
Rudder
尾舵
Front View/前視圖
Front View/前視圖
Front View / 前視圖
Front View / 前視圖
Right View / 右視圖
Right Side/右側
120
120
Left Side/左側
Right Side/右側
MODEL & SWASHPLATE SETTING
模型及十字盤模式設定
SWASHPLATE & SERVO MOVEMENT SETTING
十字盤及伺服機動作設定
