16
17
MAINTENANCE
If it should be necessary to remove / replace the propeller follow steps bellow:
1.
Unscrew the 3 screws and.
2.
Gently remove the front bracket on the thruster
3.
Unscrew the 2 propeller screws.
4.
Pull off the propeller and replace the propeller
For re-installation do the following steps in reverse order:
Removing/replacing propeller
4
1
2
3
Remember to replace all parts and make sure that everything is correct
assembled and tightened.
EN
Do not put fingers or other objects in the propeller while KICKER is switched
on (emergency kill switch magnet connected )
Do not run the motor if not in water. The motor is water-cooled and may
be damaged if running without water.
Avoid seaweed or debris getting sucked into the thruster as this may
damage the motor and propeller. If this occurs, please see the
maintenance manual.
Always practice caution when you are working with electricity in water and
with the spinning blades of the propeller. Keep body parts away from the
thruster inlet and outlet to avoid injury.
Never operate the motor if
someone is in the water close to the floating device.
THRUSTME has the right to refuse warranty claims in cases where the
object of purchase was in any way retrofitted, modified, or equipped with
other parts or accessories not expressively approved or recommended by
THRUSTME
WARNINGS
Please make sure that you have read and understood all the warnings before you
operate the KICKER
Do not attach the Magnetic Kill Switch to any other objects than
yourself. The kill switch is for your own safety and must be attached to
yourself at all times during operation.
Do not use the KICKER as diving equipment or keep it submerged.
The KICKER uses Li-Ion battery with 270 wh capacity, and transport via
airplane is thereby not permitted.
EN
MAINTENANCE
If it should be necessary to remove / replace the propeller follow steps bellow:
1.
Unscrew the 3 screws and.
2.
Gently remove the front bracket on the thruster
3.
Unscrew the 2 propeller screws.
4.
Pull off the propeller and replace the propeller
For re-installation do the following steps in reverse order:
Removing/replacing propeller
4
1
2
3
Remember to replace all parts and make sure that everything is correct
assembled and tightened.
EN
Do not put fingers or other objects in the propeller while KICKER is switched
on (emergency kill switch magnet connected )
Do not run the motor if not in water. The motor is water-cooled and may
be damaged if running without water.
Avoid seaweed or debris getting sucked into the thruster as this may
damage the motor and propeller. If this occurs, please see the
maintenance manual.
Always practice caution when you are working with electricity in water and
with the spinning blades of the propeller. Keep body parts away from the
thruster inlet and outlet to avoid injury.
Never operate the motor if
someone is in the water close to the floating device.
THRUSTME has the right to refuse warranty claims in cases where the
object of purchase was in any way retrofitted, modified, or equipped with
other parts or accessories not expressively approved or recommended by
THRUSTME
WARNINGS
Please make sure that you have read and understood all the warnings before you
operate the KICKER
Do not attach the Magnetic Kill Switch to any other objects than
yourself. The kill switch is for your own safety and must be attached to
yourself at all times during operation.
Do not use the KICKER as diving equipment or keep it submerged.
The KICKER uses Li-Ion battery with 270 wh capacity, and transport via
airplane is thereby not permitted.
EN
MAINTENANCE
WARNINGS
EN
EN