10
This document is the property of THRILL INTERNATIONAL and may not be reproduced without the company’s prior consent.
The battery charge time is approximately 12 HOURS and once recharged is sufficient to operate
the appliance with a 10 litre full CO
2
cylinder.
The appliance is fitted with four rubber feet so that it can be placed firmly on a worktop as
illustrated below.
To ensure proper functioning and the safety of those operating the appliance, the
machine must be placed on a dry, smooth, flat surface. It must then be connected to a gas
cylinder (with dip tube) filled with food grade CO
2
(E290).
DANGER
Only use carbon dioxide that is specified for food use or is marked ‘E290’. The use of
other types of carbon dioxide (e.g. industrial use CO
2
) cannot guarantee the optimal
levels of hygiene that the appliance can provide and may impart an unpleasant odour
to the glasses thus treated.
DANGER
The machine must always be used in ventilated environments as continued use of
the machine in closed, unventilated spaces decreases the percentage of oxygen
present, which may pose a respiratory hazard as it impedes breathing.
CAUTION
The cylinder used must be provided with a dip tube that reaches the bottom of the cylinder
to ensure that only carbon dioxide in its liquid state is used.
Standard carbon dioxide cylinders will not guarantee the high levels of sanitation and chilling
the appliance was designed to provide. All cylinders supplied by THRILL INTERNATIONAL are
fitted with a dip tube and are ready to be filled with E290.carbon dioxide.
SAFETY WARNING
Do not install the gas cylinders used with this machine in the vicinity of sources of heat or in
direct sunlight or install in ambient temperatures of above 50 ° C.
4.2. CONNECTING THE GAS CYLINDER
While the battery is charging, the CO
2
cylinder can be connected to the appliance.
To connect the cylinder, follow the steps listed below:
1) Install the cylinder in the desired location, away from naked flames or sources of heat
2) Position the ring nut/flange on the connector tube against the connection thread on the cylinder
3) Manually screw the connection ring nut/flange to the thread by rotating clockwise until tight,
finish tightening the nut using a No. 27 spanner.
4) Slowly release the CO
2
cylinder valve by turning the knob anti-clockwise until it is fully open
and the mechanism locks.
Identification plate
Rubber support feet
