Benchtop Arc Lamp
Chapter 4: Getting Started
Rev C, September 28, 2018
Page 13
4.6.
Setting Up on a Work Surface
All four feet on the lamp housing are height adjustable to compensate for any unevenness of a work surface. To
adjust the height, use a 4 mm hex key (one is included with the SLS401 and SLS402) to loosen and remove the
cap screws.
Figure 17 Removing Caps from the Adjustable Feet
Use a 10 mm wrench (not included) to rotate the washer underneath the bottom plate. Press lightly on the plastic
feet to make sure that they do not rotate together with the washer. A counterclockwise rotation will increase the
height. All feet are set to minimum height by default.
Figure 18 Adjusting the Height of the Supporting Feet
Summary of Contents for SLS401
Page 1: ...SLS401 SLS402 Benchtop Arc Lamp User Guide...
Page 28: ...www thorlabs com...
