THOR Jayco TALON 2021, Owner'S Manual

Page: 73 / 209

71
Section 4: Vehicle Operation
NOTE: If your RV is equipped with a touch screen control system, the
awning controls may be found on the touch screen.
Programming the Single Channel Remote (if so equipped)
1. Press the UP and DOWN buttons simultaneously until the motor
jogs. Note: after every command the motor will jog to confirm.
2. Check the direction of rotation with the UP or DOWN button. If
needed, change the direction of rotation by pressing and holding
the STOP button until the motor jogs.
3. Press and hold the PROGRAM button on the back of the transmit-
ter until the motor jogs. The buttons no longer have to be held
for the motor to run. Double check the limits are in the desired
position.
4. To reset the motor to factory mode, start with the motor connected
to power. Cut the power for 8 seconds, reconnect the power for 8
seconds, cut the power for 8 seconds and reconnect the power. The motor should start
to run (if this does not happen repeat the 8 second power cuts until the motor does run).
Allow the motor to stop on its own (do not press stop, up or down or you will have
to repeat the double power cut). Once the motor stops on its own, press and hold the
programming button for over 8 seconds. The motor should jog twice.