THOR Jayco TALON 2021, Owner'S Manual

Page: 147 / 209

145
Section 8: Plumbing System
(Be sure to have a container available for capturing system fluid.)
3. Turn the macerator pump ON.
4. Run the pump until antifreeze begins to discharge from the dump connector on the end
of the flexible hose.
5. Turn the macerator pump OFF.
6. Drain the hose by holding it at a sloped angle to remove excess water, return hose to
the stored location.
7. As an added safety measure, drain the macerator bypass valve.
De-winterize the macerator system: Emptying the black tanks in the spring will flush
antifreeze out of the macerator system.
When you are finished adding RV antifreeze
1. Turn the water pump OFF. Remove the plastic hose from the container. Leave the
black valve pointing to the clear hose.
2. Pour 1 cup of RV antifreeze into all sink drain P-traps.
3. To prevent staining, wipe the RV antifreeze out of the sinks, shower (or tub) and toilet
using a soft, dry cloth.
This will allow water to be drawn out of the fresh water tank using the pump (after the tank
is full) and into the water lines.
Refer to the
6 in 1 Utility Center – 2 Valve System
section. Make sure the low point drains
are open to flush antifreeze from the lines.
NOTE: In the spring when flushing antifreeze out of the water lines make
sure to set the (2) valves at the pump to the NORMAL position.
Nautilus P2.5 Uni-Dock Utility Center
The Uni-Doc Utility Center is located in an exterior compartment and allows you to per-
form the following functions:
 Power fill the fresh water tank for remote or dry camping
 Use the pump to supply water to fixtures from the fresh water tank