THOR Jayco TALON 2021, Owner'S Manual

Page: 192 / 209

190
Section 12: Interior
 Allow anyone to ride or occupy the bed(s) while the RV is in motion.
ALWAYS:
 Exercise care when loading cargo/vehicles in the cargo area to avoid damage to
the bed mechanism.
 Secure loads properly in the cargo area to avoid damage to the bed mechanism
from shifting or falling loads.
Sofa Lock Mechanism
When the sofa seats are unfolded into the flat (bed) position, they must be locked so they
can’t be opened into the seated position. The lock mechanism is shown above. There is a
separate lock for each seat. The lever at the left side of the lock must be pushed in towards
the label, which will lock the seat in the flat position. To release it so it can be unfolded into
the seated positon, pull the lever away from the label before flipping the seats. The arrow
in the photos is pointing to the loop used to pull the lever. This
lever slides toward the label and away from the label.
Bed Operation
The electric bed lift operates on 12-volt DC power supplied by
the tow vehicle charge line, auxiliary batteries, or power con-
verter. The recreation vehicle should be hooked up to 120-volt
AC power and have the power converter operating, if possible.
There are two separate switches used to operate the bed lift; a
red lighted master shutoff switch (Fig. 1) and the bed lift up/
down switch (Fig. 2) . Both are typically located in the command
center panel.
In some models, the master switch is still on the command center
panel but the bed-lift control switch may be located in the cargo
bay area.
The red master switch must be turned on first allowing the bed to
be lowered or raised using the bed lift control. Remember to turn
the master switch OFF after moving the beds.
When operating the beds, both beds will lower together until the
upper bed reaches an adjustable stop. The bottom bed then con-
 The powered sofa seat/beds in the cargo bay MUST be folded flat into the
sleeping position before raising them up under the upper bed for loading
the cargo bay. DO NOT operate the bed lift when seats are opened in
the seating position.
 Seats should be locked in the flat (bed) position using the sofa lock mech -
anism.