October 25
th
2013
www.thonk.co.uk
14
Music Thing Modular
Spring Reverb Module
Eurorack DIY Kit
Instructions
Version 0.9
If you use organic solder that can be
washed with water then now is a
good time to do that. Make sure you
leave your PCB to dry in a warm
place for at least 30 minutes before
progressing further.
NOTE!
If you wash the board, put
the shunt somewhere safely first.
29.
Solder the blue multi-turn trimmer
into place as shown.
30.
If you are using an accutronics digital
brick (optional) then solder this into
place now. The bricks are available in
different reverb tail lengths.
If you think you might want to switch
these out depending on taste then
you might want to use a 6 pin female
header (not included) instead of
soldering directly to the board.
NOTE! Do not heat the brick or
rework it excessively or you will
damage it, you should be aiming to
solder quickly and neatly.
31.
You can skip to step 32 if you have
the panel with RCAs on the front.
If you have a kit with rear RCA
connectors for the real spring tank
then these should be soldered now.
