October 25
th
2013
www.thonk.co.uk
6
Music Thing Modular
Spring Reverb Module
Eurorack DIY Kit
Instructions
Version 0.9
10.
Next you should solder in the 8 pin
and 14 pin IC sockets. Make sure
these sockets are soldered flush and
perpendicular to the PCB surface.
__________________________________
Then solder the 4 remaining vertically
positioned resistors:
•
10K x1
•
47K x2
•
100K x1
Solder each pair of vertical resistors
so
they
are
in
a
mirrored
configuration. This removes the
chance of them hitting each other and
shorting.
11.
Now flip the board over and solder
the one of the four 10uF Electrolytic
Capacitors into place.
NOTE! Orientation is vital on this part.
The grey stripe should be positioned
as shown and the longer lead of the
component should go into the hole
on the PCB.
100K
10K
47K
Notch!
Notch!
