October 25
th
2013
www.thonk.co.uk
9
Music Thing Modular
Spring Reverb Module
Eurorack DIY Kit
Instructions
Version 0.9
17.
You didn’t solder the pots and jacks
yet did you? Good!
Put the faceplate on (White PCB
material or Aluminium) and tighten a
few nuts on to make sure everything
is sitting true and flat.
Now solder the pots and jacks (not
the LED yet, and make sure it doesn’t
fall out in the process). There are 5
solder points per pot and 4 solder
points per jack. 31 solder joints in
total.
NOTE! It’s easy to accidentally miss a
joint at this point, so I advise double
checking the 31 joints again after
you’ve finished
18.
The LED should still be loose. Push it
up through the hole in the panel and it
should hold in place. Solder it.
Remove the front panel again. Be
careful to not bend the LED as it’s
quite exposed now.
