En
g
lis
h
9
Antenna Power
:
Set to
On
if you use an active antenna (with built-in amplifier). When set to
On
,
5 V will be present at the ANT IN connector of the receiver. Select
Off
for passive
antennas.
Channel No.
:
Select a channel that is known to carry a broadcast signal in your region. The
Signal Strength
and
Signal Quality
bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
When all settings have been made, press the
GREEN
Next
button to start scanning.
The receiver will search for all available channels. When the scan is finished, the receiver switches to
viewing mode. Now you can enjoy watching your favourite TV channels. If you get the message “No
channels found”, then check again the antenna, coaxial cable, connector and in menu if you have
reception. When this has been checked, reset the unit and follow the installation wizard again as
shown below.
TIP:
If the receiver won’t start after switching on the receiver for the first
time, reset the receiver to factory settings by pressing the
MENU
button and selecting
Load Factory Setting
in the menu
Installation
.
(DEFAULT PiN: 0000)
.
5.0 QuIck guIdE to uSIng Your rEcEIvEr
We at THOMSON understand that you can’t wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
Make sure the power switch on the back panel below the main power cord is turned ON. To turn your
receiver ON or to Standby, press
q
on the remote control or the button on the right hand side of the
front panel.
Choose the desired channel with
pq
. Alternatively, you can press the channel number with the
0~9
buttons on the remote control or press
OK
in viewing mode to display the channel list. The volume can
be adjusted with
t
u
.
6.0 oPErAtIon
Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please do also read chapter
7.0
to get familiar with the menu of
your receiver.
6.1 changing channels
Following ways are possible for changing channels with your new receiver:
- Via direct access using the
0~9
buttons.
- Via the channel list through
OK
and the
PG+/PG-
buttons.
- Via the
pq
buttons.
6.1.1 direct access via 0~9 buttons
To gain direct access to a certain channel, simply enter its number with the
0~9
buttons on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits
is possible. Just wait a few seconds and your receiver will switch to the selected channel or press
OK
immediately after selecting the channel number.
