16
OSD Timeout
:
Sets the time after which on screen banners and messages disappear. The
range is
3~10
seconds.
HDMI Audio Output
:
Toggles between
PCM
and
Bitstream
output. When
PCM
is selected, all digital
audio will be converted to stereo audio.
Bitstream
enables you to listen or
transfer Dolby® Digital/Dolby® Digital Plus* audio to the TV via HDMI or to a
home cinema set.
SPDIF Audio Output
:
Toggles between
PCM
and
Bitstream
output. When
PCM
is selected, all digital
audio will be converted to stereo audio.
Bitstream
enables you to listen or
transfer Dolby® Digital/Dolby® audio to a home cinema set through coaxial S/
PDIF. (Not Dolby® Digital Plus.)
Audio Description
:
AD. Set this option to
On
if you like to have support of an audio track that
describes the content on screen. Useful for the visual impaired.
Audio Description Volume offset
:
Select the volume from the AD audio track.
* Dolby Digital Plus, Dolby Digital and the double-D symbol are registered trademarks of Dolby Laboratories
7.3.3 general Settings
This menu allows you to manage the basic system settings of your receiver.
It consists of the following sub-menus:
Standby Mode
,
Auto Standby
and
Auto Channel Update
.
7.3.3.1 Standby Mode
You can select Active, Passive or Passive mode. In Active mode the unit will start up within
about 3 seconds from standby mode. Set to Passive, it will take about 35 seconds. Per default the
Passive combination is set so a short press on the
q
button of your remote will set the
unit to Active standby; a long press (1 second) on
q
will set the unit to Passive standby mode. It is
recommended to set your receiver to Passive Standby mode every now and then, to refresh all data
and keep your unit up-to-date. In active standby mode, the power consumption is less than 1 Watt, in
passive, less than 6 Watt.
7.3.3.2 Auto Standby
Auto Standby is a new feature that helps you reducing power consumption.
Press
pq
to highlight the menu
Auto Standby
and press
OK
advance.
When set to between
1 to 6 Hours
, the receiver will switch to standby if it doesn’t receive any
commands of the remote control during this time. Set
Auto Standby
to
Off
to deactivate the automatic
standby function.
7.3.3.3 Auto channel update
If this function is switched
On
, the unit will check if new channels are available before your receiver is
switching to standby. When switching on the next time, you will be informed if new channels are on
air and prompted to start an auto scan. This function allows you to keep the channel list up-to-date
always. If you select
Off
, the automatic channel update function is deactivated and you’ll be enabled to
use the
Delete
function in the
TV Manager
.
