THOMSON SpeedTouch 585, Reference Manual, Page: 45 / 682

ATM Commands
E-DOC-CTC-20050531-0058 v1.0
25
atm bundle ifconfig
Configure an interface from a bundle.
SYNTAX:
where:
The interface to be configured must not be connected at the time of configuration. If this should be the
case, use the command
:atm bundle ifdetach before using the command :atm bundle ifconfig .
atm bundle ifconfig name = <string>
intf = <string>
[state = <{disabled | enabled}>]
[low = <number{0-15}>]
[high = <number{0-15}>]
name The name of the bundle from which an ATM interface must be configured. REQUIRED
intf The name of the ATM interface to be configured. REQUIRED
state Enable or disable the ATM interface.
The default is
enabled .
OPTIONAL
low A number between 0 and 15.
Represents the low selector value.
Note
This parameter must only be configured when the policy of the bundle is set
to
priority (see “ atm bundle config” on page 19 ).
OPTIONAL
high A number between 0 and 15.
Represents the high selector value.
Note
This parameter must only be configured when the policy of the bundle is set
to
priority (see “ atm bundle config” on page 19 ).
OPTIONAL