THOMSON grass valley XtenDD, Manual

Page: 233 / 250

7. Installing External Devices
7 - 61 Planning and Installation - Rev. 0 / 04.2002
7.4.3 SETUP
In the Cofig E-Box menu the following settings are selectable:
The Editor config menu allow to use all mixer stages and all AUX busses of the
, if the used editor protocol command set supports only a limited number
of M/Es or AUX busses.
Example:
The standard GVG200 protocol command set supports only two M/Es and a spe-
cial DSK stage. Also only up to 4 AUX busses are supported by this protocol. The
mapping in the DD35 editor configuration card allow to control each ME stage and
each AUX bus with this limited GVG200 protocol. If an connected editor should
control the
M/E3 and PP stages instead of M/E1 and M/E2 the ” map M/E1
to ” has to be set to ” M/E3 ” and the ” map M/E2 to ” has to be set to ” P/P ”.
If the AUX Bus 11 should be used as the editor AUX bus 1 the ” map AUX
1 to ” has to be set to ” AUX 11 ”.
Setup in
Config Menu