THOMSON grass valley XtenDD, Manual

Page: 178 / 250

7. Installing External Devices
7 - 6 Planning and Installation - Rev. 0 / 04.2002
7.1.1.6 Setup and Port Configuration of A-5100 DVEous
The “DVE Effect Loop” operation requires in the A-5100 the following settings:
1. Press Remote Enable in the System menu.
2. Press Editor to highlight it (but do not switch Editor on) and adjust:
D
Protocol: A53D/VTR
D
BAUD: 9600
D
Parity: None
3. Press Editor to switch it on now.
The operation “AUX Bus control”...
1. Press Remote Enable in the System menu
2. Press AUX to highlight it (but do not switch AUX on) and adjust:
D
Protocol: AUX Bus
D
Function: Config: SWR Type : GVG 200
AUX Config: 1, 2, 3, 4
Control: chnl Select: 1A*
AUX Select: 1*
* Note:
Selection of the Aux buses is made via the DVE channel selection:
D
Selecting DVE CHNL Select 1A addresses
A/B source selection to Aux Select 1
D
Selecting DVE CHNL Select 1B addresses
A/B source selection to Aux Select 2
D
Selecting DVE CHNL Select 2A addresses
A/B source selection to Aux Select 3
D
Selecting DVE CHNL Select 2B addresses
A/B source selection to Aux Select 4
Note: Assignment of the Aux busses 5 ... 15 can be done in the switchers
menu Config/E-Box-DVE through mapping the AUX channels
Remote AUX Control of the switchers by the DVEous. Switching the input sources
of the switcher onto the AUX ports of the switchers and onto the DVEous inputs 1A,
1B, 2A and 2B.