18
KAM-HD-MULTI—Instruction Manual
Quick Start Procedure
Quick Start Procedure
Follow the procedure below for a quick start method configuration for the
Kameleon HD module:
1.
Go to the E-MEM web page (
) to select a preset audio
configuration if your audio needs match one of the four preset modes
explained in
, or set the audio
configuration on the I/O Config web page (
)
2.
Go to the I/O Config web page (
) to name inputs and outputs.
3.
Go to the System Config web page (
) to configure the input
video type (HD or SD), the video input rate, and the output timing
source. Split Screen controls are also available on this page as well as on
the HD Video Proc, SD Video Proc, and Color Correction web pages.
4.
If not already connected, connect all input and output signals and
verify component and signal presence and condition on the Status web
page (
).
5.
Go to the Functional View web
) to use the block diagram
links to configure each function in turn. Video processing must be
enabled on the System Config web page or with the Newton control
panel before adjustments can be made.
Note
Next
,
Functional View
,
and
Back
links are provided to help you navigate
through a logical configuration sequence.
6.
Use the Slot Config web page (
) to assign Slot Configuration
information such as slot name and asset number. Also link to the
2000NET module web pages to enable and disable Frame Health and
SNMP trap reporting.
7.
Use E-MEM memory (
) to store or recall configurations as
necessary.
Note
Always recall factory defaults after a software update.
8.
Refer to
for information on updating
software.
