THOMSON Grass Valley KAM-HD-MULTI, Instruction Manual

Page: 16 / 102

16 KAM-HD-MULTI—Instruction Manual
Power Up
Power Up
The front LED indicators are illustrated in Figure 9 . Upon power-up, the
green PWR LED should light and the yellow CONF LED should illuminate
for the duration of module initialization.
Operation Indicator LEDs
With factory default configuration and valid input and reference signals
connected, only the green PWR LED should be on.
Figure 9. Operation Indicator LEDs
A red FAULT LED indicates an error situation and, with the other LEDs,
can indicate the operational conditions presented in
Table 1 .
Table 1. Indicator LEDs and Conditions Indicated
LED Indication Condition
FAULT
(red)
Off Normal operation.
On continuously Module has detected an internal fault.
Flashing Frame reference or video input is missing, input does not match manual selection.
COMM
(yellow)
Off No activity on frame communication bus.
Long flash Location Command received by the module from a remote control system.
Short flash The new system configuration is being stored to the module.
CONF
(yellow)
Off Module is in normal operating mode.
On continuously
Module is initializing, changing operating modes or updating firmware. Simultaneous
CONF and FAULT LEDs on indicate FPGA load error.
Long flash Location Command received by the module from a remote control system.
PWR
(green)
Off No power to module or module’s DC/DC converter failed.
On continuously Normal operation, module is powered.
8341_03
FAULT LED
COMM LED
CONF LED
POWER LED