1.
Press
[Program]
/
[End Step]
until the green LED lights up next to the button.
ð
The display shows
‘01:01’
.
2.
If the yellow LED is flashing next to the
[Stand By]
/
[Manual]
button, press
[Stand By]
/
[Manual]
.
3.
Use the
[PATTERN]
/
[Button Setup]
or
[PATTERN]
/
[Fade Time Setup]
button to set the
number where you want to save the chaser sequence. The numbers 1…30 are desig‐
nated for freely programmable chaser sequences.
ð
All LEDs of the device briefly light up. The set number of the chaser sequence is indi‐
cated in the left half of the display.
4.
Slide the MASTER fader all the way up.
5.
Use the faders (channels 1…8) and the Latch buttons (channels 9…16) to configure the
desired settings for this step of the chaser sequence.
6.
Press
[Program]
/
[End Step]
to save the step.
ð
The number of the next step is indicated in the right half of the display.
7.
Repeat steps 5 and 6 for each chaser step. You can save up to 99 steps.
Saving a chaser sequence
Operating
DMX-controller
34
Summary of Contents for Stairville DJ-X 16
