Thermoscreens C1000AR, Installation, Operation & Maintenance Instructions Manual

Page: 13 / 16

4001150-6 Page 13 of 128
Ecopower Remote Control Operation
Push On/Off switch to turn On, then operate as follows :-
Auto Switches between manual and automatic heat regulation.
The Auto on indicator LED is lit for "Auto Mode" and un-lit
for "Manual Mode".
On/Off Turns the air curtain On or Off (when turned off the settings for
heat and fan speed are retained). If the air curtain is heating
when it is turned off with this switch the fan will run-on for a time
(approx. 2 minute) to dissipate excess heat.
Selects the appropriate fan speed (Low, Medium or High) to suit the
air curtain height and outside wind conditions. Fan speed can be
changed when unit is in either Auto or Manual Modes. A fan speed
indicator LED shows which fan speed is selected.
In "Auto Mode” the air curtain measures the incoming air temperature
and automatically selects the necessary amount of heat to keep it at
the level selected. Heating level indicator LED's go from 0% to 100%
in 8 steps to show the level selected.
In "Manual Mode” heat output can be selected as Zero, Half Heat or Full
Heat. Heating level indicator LED's go 0%, 50% or 100% to show the
level selected.
Push On/Off switch again to turn Off
Note If the mains supply is isolated or cuts-out during operation the On/Off switch will need
to be pushed again to start the air curtain when the mains supply is restored. The
safety thermal cut-out in the air curtain may operate, if this happens it will need to be
reset by a competent technician.
Higher Heat
Lower Heat
Lower Fan speed
Higher Fan Speed
On / Off
Auto Mode
Auto on Indicator
Fan Speed Indicator
Heating Level Indicator