ANNEX G – START UP CARD – PAG. 2
MACHINE DATA TABLE
Default
Heating incr. degrees/10ms 1. [ 020 ]
:
1.
KV proportional gain
2. [ 120 ]
:
2.
KINT integral gain
3. [ 50.0 ]
:
3.
KINT operating limit
4. [ 030 ]
:
4.
00C = °C / 00F = ° F
5. [ 00C ]
:
5.
Electr.frequency 50 / 60 Hz 6. [ AUT ]
:
6.
Max sealing time
7. [ 00.0 ]
:
7.
Partial short circuit factor
8. [ 01.1 ]
:
8.
Alarm enable
9. [ 255 ]
:
9.
Rated current
A. [ 30/60/90] :
A.
KD derivative gain
B. [ 040 ]
:
B.
1 = cold system compens.
C. [ 000 ]
:
C.
1 = enable serial printer D. [ 000 ]
:
D.
sealer number for printer E. [ 000 ]
:
E.
Energy control enable F. [ 000 ]
:
F.
Current tol.in pre-heat
H. [ 04.0 ]
:
H.
Phase tol.in pre-heat
I. [ 06.0 ]
:
I.
Current tol.in seal
L. [ 04.0 ]
:
L.
Phase tol.in seal
O. [ 06.0 ]
:
O.
Energy min thresold acquire P. [ 060 ]
:
P.
Burn-in Temperature
C1 [ 160 ]
:
C1.
Burn-in heating Time
C2 [ 030 ]
:
C2.
Cycle Num. to change freq. C3 [ 000 ]
:
C3.
Max.err.1/10000 period freq. C4 [ 900 ]
:
C4.
SETTING DATA TABLE
Default
Heating current for test
0. [00.0]
:
0.
V-I istantaneus for test
1. [ xxx ]
:
1.
I read istantaneus for test
2. [ xxx ]
:
2.
Maximum active current
3. [ 45/90/135 ] :
3.
Working active current
4. [ xxx ]
:
4.
Heating factor
5. [ 0.9 ]
:
5.
V-I 100 degree
6. [ xxx ]
:
6.
I-V absolute max. rating
7. [ 3.6 ]
:
7.
I-V rated
8. [ xxx ]
:
8.
Mains supply frequency
9. [ xxx ]
:
9.
Voffset
A. [ 400]
:
A.
Max sealing temperature
B. [ 250 ]
:
B.
Temper.gradient(degree/10sec)C. [ xxx ]
:
C.
