7
3. ensure that the mounting is according with the information’s
on the enclosure.
4. fix the dcc with the anchors provided for the type of surface.
5. check that the dcc is adequately fixed to the wall or ceiling.
step 4: ConduCtor Connexions
consult the diagram on the next page for all details on the cable
connections configuration. this diagram is also found under the dcc
cover.
Current transformers (Ct) installation and connections
1. open the ct.
2. install the ct around the main power cable of the panel.
3. check the correct polarity on the cts.
4. connect the ct cables to the terminal block, provided for
that purpose, inside the dcc.
extension of current transformers’s wire
if the dcc is installed remotely from the panel, it is possible to extend
the wiring supplied with the current transformers up to a maximum
of 25 feet.
additional wire must be 600V rated, minimum 18 aWg (1mm),
4 conductors shielded twisted (ex: ft4 shield. 4c fas #18
or equivalent).
step 5-a: dip switCH proGramminG
For main power supply
1. identify the set-up section on the dcc.
2. set up the section as per the layout corresponding to the main
power supply:
models
main power supply
60a 70a 80a 90a 100a 125a 150a 200a
dcc-9-30a
✓
✓
✓
✓
✓
✓
✓
✓
dcc-9-40a
✗
✗
✓
✓
✓
✓
✓
✓
dcc-9-50a
✗
✗
✗
✗
✓
✓
✓
✓
dcc-9-60a
✗
✗
✗
✗
✗
✓
✓
✓
step 5-B: ConFiGuration oF tHe transFormer
voltaGe at 208v
(only for application at 208V, single phase)
1. locate the orange cable connected
to the 240V terminal (factory setting).
2. Unplug the orange cable from
the 240V terminal.
3. plug the orange cable to the 208V terminal.
T
24V
240V
208V
COM
TRANSFORMER
TRANSFORMATEUR
50VA/240/208V
Orange
T
24V
240V
208V
COM
TRANSFORMER
TRANSFORMATEUR
50VA/240/208V
Orange
i
Warranty automatically void if electrical power is supplied to the
dcc and the transformer is not set at the appropriate voltage.
warninG
step 6: start-up
dCC power supply
1. supply electrical power to the dcc.
2. Wait ten (10) seconds.
3. check if the contactor is switched on.
4. check the pilot light:
Green
at all time: compliant installation, go to the next step.
red
: refer to the lights code section.
Summary of Contents for DCC-10 series
Page 2: ...2...
