ThermoFisher Scientific Wellwash 4, Service Manual

Page: 37 / 156

Chapter 5: Installation
Thermo Scientific Wellwash
®
4 Mk 2 User Manual Rev.2.3, Cat. no. 1507340 13
5 Installation
5.1 Installation check list
The section on installation will contain an outline of the points mentioned in the
check list below.
Table 5.1 Installation check list
Tick Item
‰
Unpack the Wellwash 4 Mk 2 instrument carefully. Refer to 5.2.1. Keep the
original packaging and packing material for future transportation.
‰
Check the delivery for completeness. Refer to 5.2.2.
‰
Check for damage during transport. Refer to 5.2.3.
‰
Place the instrument on a normal laboratory bench taking into account both
the environmental and technical prerequisites. Refer to 5.2.4 and 5.2.6.
Leave sufficient clearance on both sides and at the rear of the unit.
‰
Install the instrument:
‰
Remove the transit screws. Refer to 5.3, step 1.
‰
Check the voltage and frequency of the electrical supply. Refer to 5.3,
step 2.
‰
Remove the pinch valve holder. Refer to 5.3, step 4.
‰
Install the wash head. Refer to 5.3, steps 5 and 6.
‰
Connect the tubing and the liquid level sensor cord to the pump unit. Refer
to 5.3.1, steps 1 to 5.
‰
Connect the washer unit to the pump unit. Refer to 5.3.1, steps 6 and 7.
‰
Fill the wash bottle and tighten both bottle caps. Refer to 5.3.1, steps 8
and 9.
‰
Slide the plate carrier to its place. Refer to 5.3.1, step 10.
‰
Connect the mains supply cable (cord) to the mains input socket. Refer
to 5.3.2.
‰
Carry out the operational check. Refer to 5.4.
5.2 What to do upon delivery
5.2.1 How to unpack
Move the unpacked instrument to its site of operation. Unpack the Wellwash
4 Mk 2 instrument and accessories carefully with the arrows on the transport
package pointing upwards. The following notes and instructions are sent with
the instrument and are immediately available when you open the package:
•
the Warranty Certificate card
•
the packing instructions/packing list
• the Transportation discrepancy report
•
the User Manual
Caution: DO NOT touch or loosen any screws or parts other than those specially
designated in the instructions. Doing so might cause misalignment and
will invalidate the instrument warranty.