Ramsey Oretronic IV Tramp Metal Detector REC 4479C
Page 21
•
Disconnect incoming power at mains before beginning any installation or wiring procedures.
•
Use extreme caution when testing in, on, or around the electronics, PC boards, or modules.
There are voltages in excess of 115V or 230V in these areas.
•
Covers over the electronics should always remain in place during operation. Remove only for
maintenance procedures with the machine’s power OFF. Replace all
covers before resuming
operation.
WARNING.
Use only the procedures and new parts specifically referenced in this manual to ensure
specification performance and certification compliance. Unauthorized procedures or parts can
render the instrument dangerous to life, limb, or property.
WARNING.
All wiring must be done in accordance with the field wiring diagrams, applicable sections
of the National Electrical Code, and local electrical codes.
WARNING.
Keep hands and clothing away from all moving or rotating parts.
WARNING.
This equipment should not be operated at more than the production rate stated on your
Equipment Specification sheet or used in applications other than those stated in the original order.
Equipment Handling
The TMD IV coil support structure and coil(s) are normally packaged on a wooden skid and may be lifted with a
forklift or crane. Do not lift the equipment using the support structure; use the exterior wooden structure. Use
care when lifting this equipment to avoid damage to the coil(s).
WARNING.
This equipment may be heavy. Employ a two-person lift for any configurations housed
in a metal enclosure.
Inspection and Unpacking
The Tramp Metal Detector has been properly packaged for shipment. Inspect all packages before opening. If
there is any evidence of shipping damage, notify the shipping carrier immediately; the carrier may be
responsible for the damage. After unpacking, inspect the unit for broken or damaged components.
After unpacking, inspect the unit for broken or damaged components.
Storage
The Tramp Metal Detector and associated equipment can be safely stored, with the cover secured and hole
plugs installed, in ambient temperatures between -50°C to +58°C (-58°F to +136°F). The control unit should be
protected against moisture.
Installing the TMD IV
This section provides procedures for installing the coil support structure and coils and for mounting and wiring
the control unit. The installation procedures are different for dual coil and under belt single coil TMD IVs.
