Orion 8010cX Ammonia Analyzer
System Running | 27
Figure 23. Main Interface of Orion 8010cX
Ammonia Analyzer
Navigation Bar:
Navigation bar is mainly used for quickly
entering specific interfaces. You may click the navigation bar
to enter to the corresponding interfaces, which includes
return, main interface, parameter setting, recording, general
setting, manual operation (measurement) and maintenance.
Among them, the return icon is only valid when it is not on the
main interface, and is used to return to the upper directory of
the current UI interface. The main interface UI quickly returns
to the main interface under any interface. The navigation bar
would appear in each interface.
Only in the main interface, you can click the arrow “ ”in the
middle of the navigation bar to hide the navigation bar. After
that, click “ ” to return to the state with the navigation bar.
Equipment Name, Time and Date:
The equipment name is
used to indicate the name of the current equipment.
Time/Date displays the current time/date.
Equipment Status Identification:
The equipment status
identification is used to indicate the status of the equipment.
Under normal conditions, the equipment status identification
is green
❤
type. When there is a fault or alarm, the
identification changes to another form. See
.
Figure 24. Main Interface of Orion 8010cX
Ammonia Analyzer in Case of Alarm
Icon Identification Area:
Icon identification area is used to
display the currently set reaction temperature, absorbance
measured last time, and currently set measuring range.
Measurement Index and Measurement Result Display
Area:
The area is used to mark the items and test results
tested by this instrument. In the measurement result display
area, the unit and current measurement mode of the
measurement result can be displayed at the same time.
Progress Bar:
The progress bar is used to indicate the
progress of the current operation. Through the progress bar,
the current operation process can be judged.
Last Measurement and Calibration Time Display Area:
It
is used to display the last measurement time and the last
calibration time. When the calibration time is relatively long
ago, automatic or manual calibration is recommended.
Main Interface Operation Area:
The main interface
operation area is used to operate the current running state,
including running and stop. The current operation of the
equipment can be stopped or the equipment can be started.
In the idle state, click the start button to start a measurement;
When the system executes the process, click Stop, and the
measurement system would enter the reset and emptying
process and terminate the current operation. Therefore,
caution is required when executing the stop operation.
1
Navigation Bar
6 Analog Signal Output Display
Area
2
Equipment Name,
Time and Date
7 Measurement Index and
Measurement Result Display
Area
3
Equipment Status 8 Progress Bar, Last
Measurement and Calibration
Time Display Area
4
Login Port
9 Main Interface Operation Area
5
Icon Identification
Area
