57
to
3. Enter the protocol name, for example,
Test1
, by using the number and
letter keys, and then press the
OK
button.
Note!
You cannot use the protocol name “
Untitled
”.
Note!
The results of an “
Untitled
” protocol are not saved unless you save the active protocol,
including the measured run data with a new name.
Chapter 8: Viewing Results
The results can be viewed in several formats (depending on the protocol settings): raw data in list and
table format, calculated results in list and table format, and graphs (calibration or kinetic curves).
You can disable/enable samples and sample replicates from the raw data in table format. If the user
enables automatically disabled data, the user is responsible for data quality.
After the run has finished, the data view of a run is automatically shown (see example view below).
The order of the data views (results) to be shown is according to the following list, depending on
which calculations were used in the protocol:
Assay quality control (if failed). The results of a failed run are flagged.
Interpretation
Quantitative results
Precalculated results
Raw data
1. Press the
F3
(
Menu
) key to enable menus of different data views in order
to view them.
