Thermo Scientific MIRAN 205B Series, Instruction Manual, Page: 73 / 214

Chapter 7 Configuration and Setup
7-19
ANALYSIS SETUP PAGE 3
To continue with the analysis setup, press the down arrow key from the second Analysis
Setup Menu. The third Analysis Setup Menu, shown below, is displayed.
┌────────────────────────────────────────┐
│╒════════ SUMMARY ════════╕ ANALYSIS SETUP │
││ Passcode: Off │ 1=Passcode │
││ ───── │ ───── │
││ Capacity: 50/200 │ 2=Log capacity │
││ Locations: Off │ 3=Location list │
││ Reprt Out: As logged │ 4=Report output │
││ │ │
│└───────────────────────┘ =More │
└────────────────────────────────────────┘
Analysis Setup Page 3 Menu
The current application setup summary is displayed on the left and the menu of selections
on the right.
Passcode
To turn the passcode on or off or to change the passcode, press
1
(Passcode) from the
third Analysis Setup Menu. The Passcode Menu is displayed. Press
1
to turn the
passcode feature off,
2
to enable the feature, or
3
to change the code.
If
3
is pressed, the display requires entering the new passcode. The passcode can contain
from 1 to 10 digits. After entering the new passcode, press the
ENTER
key. If the
password is accepted, enter the password again to verify it. If this is also valid, the
display responds "-ACCEPTED-."
Log Capacity
To configure the log capacity, press
2
(Log capacity) from the third Analysis Setup
Menu. The Log Capacity Menu is displayed. Press
1
to specify the maximum number of
sites and
2
to specify the maximum number of locations per site. The maximum number
of sites can be from 1 to 50 and the maximum number of locations per site, from 1 to
200.