Thermo Scientific ALPHA COND 550, Manual

Page: 29 / 40

Instruction Manual
Alpha-
COND 550
23
measuring range is selected to ‘0.0 to 200.0 mS/cm’.
Press
▲
or
▼
key to set the line resistance of the sensor cable
connected to the monitor.
Press ENT key to confirm your selection.
4
Reset to factory defaults:
The display shows ‘ nO dEF ’.
Press
▲
or
▼
key to select:
nO dEF : Not default reset of the monitor. User configured values
remain active, when confirmed by pressing ENT key.
FCt dEF : Reset all settings of the monitor to factory defaults, when
confirmed by pressing ENT key.
CAL dEF : Reset all calibration settings of the monitor to factory
defaults, when confirmed by pressing ENT key.
NOTE : Refer section 6 for factory/calibration default settings
Press ENT key to confirm your selection.
- If ‘ nO dEF ’ was selected, the monitor reverts to Cnfg screen.
Press
▲
or
▼
key to access other setup screens or press
▲
and
▼
key simultaneously (escape) to return to measurement
mode.
- If ‘ FCt dEF ’ or ‘ CAL dEF ’ was selected, the monitor performs the
selected reset and returns to measurement mode.
Press
▲
or
▼
key to access other setup screens or press
▲
and
▼
key
simultaneously (escape) to return to measurement mode.
To exit from any intermediate steps, press
▲
and
▼
keys simultaneously
(escape). The monitor returns to the first screen configuration settings ( Cnfg ).