Refrigeration Service Operations (Rev. 04/02)
73
Assembly/Installation
After cleaning and inspecting all parts, reassemble the
valve.
1.
Install the screen in the bottom cap.
2.
Install the new stem in the bottom cap.
3.
Install new gaskets on both sides of the seat. Oil the
gaskets in compressor oil before installing.
4.
Use the three-way valve seal installation tool P/N 204-
1008 to install a new seal on the piston. This prevents
the seal from being stretched and damaged.
a.
Place the tapered tool over the piston.
b.
Lubricate the seal with refrigeration oil.
1
1.
Press by Hand
4.
Tapered Tool
2.
Pipe
5.
Piston
3.
Seal
Seal Installation with Tool P/N 204-1008
ARA166
2
3
4
5
c.
Slide the seal onto the tapered tool with the spring
side facing away from the piston.
d.
Use the pipe to hand press the seal onto the piston.
5.
Place the piston slot on the stem and secure with spring
clip. The open part of the clip should be on the opposite
side of the piston slot.
6.
Install the spring and top cap.
7.
Line up the passageways in the cap and body. Failure to
line up the holes will result in improper operation of the
valve.
8.
Install the bolts and tighten in rotating sequence.
9.
Install the pilot line and pressurize the system with
refrigerant to check for leaks.
10. If there are no leaks, evacuate the system and recharge
with the proper refrigerant.
11. Run the unit to check for proper three-way valve
operation.
THREE-WAY VALVE CONDENSER
PRESSURE BYPASS CHECK VALVE
REPAIR
Removal
1.
Remove the refrigerant charge.
2.
Unscrew the condenser pressure bypass check valve
cap from the three-way valve.
3.
Remove the snap ring.
4.
Unscrew the check valve stem by using a screwdriver
in the slot provided.
NOTE: The spring and valve are held in by the stem.
While removing the stem, use care so the spring and
valve are not lost.
Summary of Contents for SB-III 30 SR+
