Thermo Electron iEMS, User Manual

Page: 14 / 61

Chapter 5: Installation
iEMS

Incubator/Shaker User Manual Rev. 3.0, Cat. no. 1506200A 14
5 Installation
5.1 Installation check list
The section on installation will contain an outline of the points mentioned in the
check list below.
Table 5.1 Installation check list
Tick Item
!
Unpack the iEMS Incubator/Shaker instrument carefully. Refer to 5.2.1.
Keep the original packaging and packing material for future transportation.
!
Check the delivery for completeness. Refer to 5.2.2.
!
Check for damage during transport. Refer to 5.2.3.
!
Place the instrument on a normal laboratory bench taking into account both
the climatic and technical prerequisites. Refer to 5.2.4 and 5.2.6. Leave
sufficient clearance on both sides and at the rear of the unit.
!
Install the instrument. Refer to 5.3.
!
Connect the mains supply cable (cord) to the mains input socket. Refer to
5.3.2.
5.2 What to do upon delivery
5.2.1 How to unpack
Move the unpacked instrument to its site of operation. Unpack the iEMS
Incubator/Shaker instrument and accessories carefully with the arrows on the
transport package pointing upwards. The following notes and instructions are
sent with the instrument and are immediately available when you open the
package:
• the Warranty Certificate card
• the packing instructions/packing list
• the transportation damage and discrepancy report
• the Manufacturing / Quality Report
•
the User Manual
Caution: Do not touch or loosen any screws or parts other than those specially
designated in the instructions. Doing so might cause misalignment and
will invalidate the instrument warranty.
To lift the instrument, put your fingers under the bottom on both sides and lift it
with your back straight.
Caution: When unpacking the instrument, it is recommended that two people lift
the instrument together, taking proper precautions to avoid injury.