Plasma Cutting Power Supply, Auto-Cut
®
300 XT™
Operating Manual No. 0-5300
Published by:
Thermal Dynamics Corporation.
2800 Airport Rd.
Denton, Texas 76207
www.thermal-dynamics.com
© Copyright 2013, 2014, 2015 by
Thermal Dynamics Corporation.
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher is
prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or dam-
age caused by any error or omission in this Manual, whether such error results from negligence,
accident, or any other cause.
Publication Date: April 22, 2013
Revision Date: May 27, 2015
Record the following information for Warranty purposes:
Where Purchased: ___________________________________
Purchase Date:______________________________________
Power Supply Serial #:_______________________________
Torch Serial #:_______________________________________
®
!
WARNING
Read and understand this entire Manual and your employer’s safety practices
before installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer’s
best judgement, the Manufacturer assumes no liability for its use.
Summary of Contents for AUTO-CUT 300 XT
