Thermal Dynamics AUTO-CUT 30 O2, Operating Manual

Page: 39 / 148

Manual No. 0-4818 Auto-Cut 300
2
3-15 INSTALLATION
3.10 Connect Fiber Optic Cable to CCM
1. Remove the strain relief securing nut from the strain relief on the fiber optic cable(s). Loosen the strain
relief dome nut from the strain relief.
2. Pass the cable connector through the appropriate opening. Slide the strain relief securing nut onto the
cable. Make a loop of the cable; carefully press the cable connector into the appropriate receptacle on the
internal control module.
3. Tighten the strain relief onto the cable(s). Do not overtighten.
To Gas Control Module
To Remote HMI
(if installed)
Profile Detail, Fiber Optic Cable Installation
Cable Receptacles
To Slave Power
Supply
(if installed)
Art # A-06793