Thermal Dynamics AUTO-CUT 30 O2, Operating Manual

Page: 30 / 148

Manual No. 0-4818 Auto-Cut 300
2
3-6 INSTALLATION
Check / Adjust Input Voltage Configuration
1. The 230/460VAC power supply includes a voltage configuration board which must be positioned to match the
primary input voltage. Remove the power supply left side panel and locate the voltage configuration board on
the inverter module. The input voltage configuration is shown at the top of the board.
WARNING
There is a voltage configuration board on each inverter module. Power supplies with more than one
inverter module require that all voltage configuration boards must be configured identically.
2. If necessary, unplug the connector at the top right corner of the board, remove the board and re-install it with the
correct input voltage shown at the top of the board.
3. Re-connect the connector. Re-install the power supply side panel.
Art # A-04856_AB
1. Unplug connector
2. Remove bolts.
3. Invert board.
4. Re-install board.
5. Plug in connector.
208/230V / 460V
Input Voltage Board
(Shown in 460V Position)
Inverter Module