CM Oven Service Manual
Lit. No. 94-30-006B
Page 29
9.
Cut the leads of the new light assembly
approximately 3˝ from the body.
10. Remove 3/8˝ of insulation from the cut
lead ends and the wiring harness.
11. Twist two small wire nuts over the ends
of the leads.
1. Position the wiring neatly inside the
oven liner cutout for the halogen light
and press the assembly into place so its
edges are flush with the outside of the
liner.
2. Install the bulb in the socket.
3. When you reinstall the metal screen, do
not install screws at the four corners (see
Step 6 on the previous page).
4. When you reinstall the rack support,
make sure you position it with the stop
towards the back (see Step 4 on the pre-
vious page).
Keep Edges
Flush With Liner
Install Halogen Bulb
Tech Tips!!
When you reassemble the halogen light as-
sembly:
