10/2021 V 1.1
VIEW 22
14/17
A�ach the Glass to Glass Hinges to the
door and �ghten.
Use 5mm Packers in gap and evenly
�ghten the screws un�l the gaskets are
just “nipped”.
Tighten all screws to 15.6N.
DO NOT fit the Cover Plates yet.
Measure the width of the Door (glass
width). Cut the Bo�om Door Seal
accordingly.
Trim the outside edges on both ends to
allow the two Ver�cal Seals to touch
the Glass.
A�ach the Seal ensuring the Seal is
correctly oriented.
Push both Ver�cal Seals down as far as
they can go.
With a straight edge, mark where the
Seals will be trimmed. Remove the
Seals and trim with a fine toothed
junior hacksaw so they are flush with
the tops of the Glass Panels.
Replace the seals.
Outside of
enclosure
41
42
43
44
