10/2021 V 1.1
VIEW 22
07/17
Using purpose built “Glass Li�ers”,
carefully place the Inline Panel on to
the Underframe Gasket and push
against the Return Panel.
Note the orienta�on and posi�on of
the Panel, this can be determined by
any holes or a�ached labels.
Remove and replace the Panel adding
or subtrac�ng spacers as necessary to
level the Panel (to a maximum height
of 5mm inside the Underframe).
Check the Panel is level using a Spirit
Level. If the difference between the
two Panels is greater than 5mm, it may
be necessary to lower the Return
Panel.
Pull Inline Panel away from the Return
Panel. Add 1mm Packers to both sides
of Inline Panel in the Underframe.
Remove the protec�ve adhesive strip
from the Tape. Gently push the top of
Return Panel away from Inline Panel.
From the bo�om, push the Inline Panel
towards the Return Panel.
Start to pull the Return Panel back
when approaching the top.
Use the Nylon Block to ensure that the
Inline Panel is level with the edge of
the Return Panel.
Ensure the two panels are firmly fixed
together and remove Inline Packers.
25
26
27
28
