9
If your fan was ordered with the optional LED light, begin by identifying all parts
(see Step 1), then follow steps (a) through (d).
7
(a) Remove bottom hub plate held
by three screws shown here.
This will access light kit lead wires
and 2-pin connector. Set aside
screws for step (b).
(b) Position light plate so that the
three recessed screw holes are
aligned with screw posts on center
hub. Light kit lead wires and 2-pin
connector must be routed though
center hole of light plate. Use three
screws from step (a) to fasten
light plate in place.
(c) Feed light kit lead wires and
2-pin connector through center
hole of LED board and carefully
insert into 2-pin block. Gently
push any excess wire behind light
plate and position LED board over
screw holes on light plate. Align
screw holes on isolation cover with
notches in LED board and screw
holes in light plate. Use pan head
screws to secure isolation cover
and LED board to light plate.
(d) Align slots in glass diffuser with
studs on inside edge of light plate,
press up and gently rotate securely
into place. There is no need to
forcefully over tighten glass diffuser.
2-pin connector
secure cover
and board
align board w/ holes
WARNING!! Power must be disconnected at circuit
breaker prior to any contact with electrical wires.
light kit screw pack
