10
8
Wall controls and remote handsets communicate with the canopy receiver using
radio frequency transmission. Each device (wall control and remote handset)
is factory set to a unique channel to avoid unwanted interference with other fans
installed nearby. A receiver can be paired with up to two devices (wall c
remote handset or two remote handsets). To pair a wall control or remote handset,
proceed as follows:
(a) Remove face plate of wall control and/or battery cover of remote handset.
Place battery (included) into wall control and/or remote handset as shown here.
(b) With the breaker switched to the on position, turn power on at the wall control
(bottom of control face). If your fan was ordered with a remote control only,
turn power on at the on/off wall switch. If your fan is installed without a switch leg,
you will need to use the breaker as your primary power switch for device pairing.
(c) Within 1-minute of turning power on, press and continuously hold the
Fan Off button
on your wall control (or remote control) for approximately
5-seconds. Upon successful pairing, the fan blades will move slightly back-
and-forth. If installed with a light, the light will also turn on and then off.
(d) Repeat the pairing process with second device if you ordered your fan with
both the wall control and a remote handset.
Control Pairing
Fan Installation
(continued)
WARNING
See Pages 2-3
POWER OFF
Circuit Breaker
face plate
battery cover
Control Pairing Quick Reference:
(a) Place batteries in control.
(b) Power cycle the fan (switch power off, then on)
(c) Press and hold fan off button until paired (approx. 5 seconds)
(d) If applicable, repeat for next controller (wall or remote)
