8
Fan Installation
(continued)
WARNING
See Pages 2-3
POWER OFF
Circuit Breaker
Insert a blade screw and washer from the hardware pack through the center blade
hole and position under the motor so that the screw is aligned with the “center”
hole position of any group of three screw holes. Using the large hex key from the
hardware pack, secure blade to motor, but do not over tighten. Repeat for the two
outside screw positions on blade one. Follow the same steps for the second and
third blade. Once all blade screws and washers are in place, gently tighten all
screws with the hex key.
5
If your fan was ordered with the optional LED light,
skip to Step 7. Otherwise, align threaded rod in
bottom cap with center hole on bottom hub.
Rotate until threaded rod hits resistance against
hub plate. There is no need to over tighten or
apply excessive torque.
6
