To start fire:
•
Press the on/off switch to the ON position.
•
Press the high/low switch to the HIGH position.
•
The electronic solenoid pack will start to click.
•
Gas will then be released and ignited at the pilot valve.
•
The safety sensor will allow the main burner pipe to ignite and flames will appear. The whole process will take between 10-20 seconds.
•
Once the flame appears, it can be turned down to the low setting by pressing the high/low switch to LOW.
GD3 OPERATING INSTRUCTIONS
To shut down fire
:
•
Press the on/off switch to the OFF position.
•
The gas will automatically be shut off to the pilot and the burner. The flame will then extinguish.
TROUBLE SHOOTING
PROBLEM
PROBABLE CAUSE
CORRECTION
Appliance doesn't start
1. No gas supply
2. No power supply
3. Low or poor pilot flame
4. Signal from flame rectifier interrupted
5. Signal to sparker electrode interrupted
6. Incorrect sparker electrode gap
1. Check gas supply
2. Check power supply
3. Check flame size and pressure
4. Check flame rectifier and wire to sit pack
5. Check sparker gap and wire to sit pack
6. Check sparker electrode gap is 3mm
Appliance shuts down
1. Low gas supply
2. Low or poor pilot flame
3. Signal to flame rectifier interrupted
1. Check gas supply
2. Check flame size and pilot flame pressure
3. Check flame rectifier and wire to sit pack
Flame in not running the full length
of the burner
1. The firebed is not aligned to the
burner
1. Reset the firebed to the specific model
SPECIFICATIONS.
Flame is yellow and sooty
1. Primary aeration ports have a
blockage
1. Check primary aeration ports for
blockage and clear if required
No flame at the pilot
1. Primary aeration ports have a
blockage
1. Check primary aeration ports for
blockage and clear if required
21-3-2017 VERSION 4 Page
of
19
20
The GD3 fire has been designed to be simple to use. It is controlled by a wall switch, which must be installed by a qualified electrician.
Summary of Contents for GD3
Page 1: ...GD3...
