www.tgogc.com
Pull Up/Assisted Pull Up -
TGO810
The Maintainer should perform the following checks and actions to the equipment:
General Regular Visit:
•
Operate the machine and identify if there are any issues such as noises or stiffness. Try and
diagnose where this is coming from and resolve via maintenance oil or adjustment if possible. If this
problem cannot be resolved, leave the product safe and seek advice from TGO office info@tgogc.
com
•
Remove graffiti from paint and signage with non-abrasive cleaners (tested for suitability)
•
Inspect and report any damage to signage
•
Inspect and report any damage to components
•
Check all the fixings to ensure they are tight and secure. Retighten or replace where appropriate
•
Specifically check the 8x structural inward facing bolts visible from the outside of the main
framework
[see image label 1]
. If any of these are loose remove them (one at a time) and replace
with a new fixing ensuring Loctite 270 is applied. If it is difficult to fit the new fixing, then you will
need to clean out the threaded hole in the bearing housing
•
Touch up any paint damage
•
Specifically check the spoke pins at the bottom. Ensure both are present and correct. If any are
missing, close the piece down and order some more.
[See image label 2]
Quarterly (compulsory):
•
Perform all general regular visit maintenance listed above.
•
Spray all moving parts (joints only) with a 3in1 maintenance oil (not penetrating oil).
[See image
label 3]
•
Clean off any salt deposits
•
Log quarterly site maintenance visit
Bearing replacement
[See image label 3]
:
•
The correct specification of bearing and specific instructions can be supplied by TGO. Bearings
must only be changed with the correct tools. Oilite bearings are used and due to the very soft
material the bearings should be pressed in and not impacted, it may be necessary to ream replaced
Oilite bearings to obtain the correct fit. Replaced Oilite bearings will require additional lubrication
during a settling period
Handle replacement:
•
The maintainer should have stock of handles on his or her maintenance visits. The receiving
handle should be cleaned to remove surface contamination. A small amount of adhesive (TGO can
supply appropriate glue) should be applied to the inside of the handle and to the machine handle,
the handle can be rotated onto the arm to give the glue a good coverage in the process. The handle
will be at risk of removal until the glue cures
1
1
3
2
2
3
3
www.tgogc.com
13
