www.tgogc.com
www.tgogc.com
51
Remove the graphic plate
from the console via the
four (4) M5 Pin Torx screws.
Retain the screws and put
the graphics plate to one
side.
Remove the four (4), now
exposed, M8 Pin Torx Screws
which hold the console to
the spinning bike frame.
Retain the fixings in a safe
place.
NOTE 1: Take care as to not
damage the cabling as the
console is pulled away from
the spinning bike.
To remove the USB, unplug
the two spade connector
ports.
Remove the four (4) M3 Nuts
and washers, and slide
the USB board off the M3
inserts.
Reapply the new USB board
and reverse the above
steps to reapply the
console.
1
2
3
4
3
1
2
Energy Spinning Bike - LGH -
TGO971
It may be necessary at some stage to maintain and access the LGH or the USB. The LGH is the electrical
heart of the Cardio Charge (Glow and Flow) Spinning Bike and is what manages the electricity produced
from the equipment. This should rarely need visiting, but in the event it does, TGOGC have provided some
basic instructions (below) on how to access it.
The USB is what TGOGC call a consumable item and therefore not warranted by TGO. However, it is a low
cost product and is simple to replace.
1
3
4
Unfasten the four (4) M8
Pin Torx Screws from the
side of the Spinning Bike
to remove and access the
front of the LGH. Place the
clad and fixings to one side.
The LGH will be bolted in a
vertically standing position
as shown in the diagram.
To remove the LGH fully, you
will need to unfasten the
two (2) M4 fixings, accessed
from the rear of the LGH
box.
NOTE 1: LGH release will
require the removal of the
rear clad, by unfastening
the four (4) M8 Pin Torx
screws and two (2) top M6
Pin torx screws.
To remove the LGH box
lid, in order to access the
electronics, all four (4) M4
Phillip Head screws will
need to be removed.
NOTE 2: Retain all fixings in
a secure location during
maintenance.
NOTE 3: The lid screws
should be torqued to
5-7.5lbf.in, as to retain the
IP rating.
Reverse Procedure to
reassemble.
2
3
2
1
