www.tgogc.com
www.tgogc.com
39
Remove the graphic plate
from the console via the
four (4) M5 Pin Torx screws.
Retain the screws and put
the graphics plate to one
side.
Remove the four (4), now
exposed, M8 Pin Torx Screws
which hold the console to
the cross trainer frame.
Retain the fixings in a safe
place.
NOTE 1: Take care as to not
damage the cabling as the
console is pulled away from
the cross Trainer.
To remove the USB, unplug
the two spade connector
ports. .
Remove the four (4) M3 Nuts
and washers, and slide
the USB board off the M3
inserts.
Reapply the new USB board
and reverse the above
steps to reapply the
console.
1
2
3
4
3
1
2
Energy Cross Trainer - LGH -
TGO862
It may be necessary at some stage to maintain and access the LGH or the USB. The LGH is the electrical
heart of the Cardio Charge (Glow and Flow) Cross Trainer and is what manages the electricity produced
from the equipment. This should rarely need visiting, but in the event it does, TGOGC have provided some
basic instructions (below) on how to access it.
The USB is what TGOGC call a consumable item and therefore not warranted by TGO. However, it is a low
cost product and is simple to replace.
1
3
4
Remove the four (4) Lower
M8 Pin Torx Screws and
the two (2) top M8 Pin Torx
Screws, with washers.
The rear clad should be
placed to one side.
NOTE 1: This clad may be
held under tension and
spring mildly upon loosening
the fixings.
The LGH will be bolted in a
vertically standing position
as shown in the diagram.
To remove the LGH fully, you
will need to unfasten the
two M4 fixings, access from
the rear of the Parakeet
box.
To remove the LGH box
lid, in order to access the
electronics, all four (4) M4
Phillip Head screws will
need to be removed.
NOTE 2: Retain all fixing in
a secure location during
maintenance.
NOTE 3: The lid screws
should be torqued to
5-7.5lbf.in, as to retain the
IP rating.
Reverse Procedure to
reassemble.
2
3
2
1
