8
CONTROLS AND INSTRUMENTS
FUEL GAUGE
The fuel gauge is shown in Figure 5 and 6. The
needle indicates the amount of fuel in the tank.
Figure 6 - Temperature Gauge and Fuel Gauge
FUEL SHUTOFF VALVE
The fuel shutoff valve is shown in Figure 7. To open
the fuel shutoff valve, move the handle so
Figure 7 - Fuel Shutoff Valve
that it points straight up and down. To close the fuel
shutoff valve, move the handle to the horizontal
position. Always shut off the valve ‘A/hen servicing
any portion of the fuel system.
WARNING LIGHTS
The engine oil pressure, charge indicator, glow plug
indicator and air cleaner warning lights are located
as shown in Figure 5. When the key switch is turned
“ON” these lights will come on. After the engine has
been started, the lights should go out within a few
seconds. If they do not go out:
•
Engine oil pressure warning light : Stop the
engine immediately and investigate the
cause. It is important to remember that this
light indicates oil pressure only. The operator
must regularly check the crankcase for proper
oil level.
•
Charge indicator warning light : This is an
indication that the charging system is not
operating normally. Investigate the cause as
soon as possible, otherwise the battery will
become fully discharged.
•
The glow plug indicator warning light : This
light comes on when turning the key switch to
the “HEAT” position and “START” position.
Refer to page 14 for starting engine
information.
•
Coolant warning light: If the light comes on,
check the coolant level in the coolant reserior.
Add coolant so the level is between FULL and
LOW marks on the side of the reseroir.
•
Air cleaner warning light : This is an
indication that the air cleaner element is
clogged. Disassemble the air cleaner, and
clean. Refer to page 40.
•
Parking brake warning light: This light comes
on only when the parking brake is applied.
Release the parking brake before moving the
tractor.
NOTE: Make certain that all warning lights turn on
for a moment when turning the key switch to the
“START” position. If one of the warning lights does
not turn on, the bulb should be replaced.
PROOF-METER
The Proof-Meter is located on the right side of the
instrument panel, Figure 5 The Proof-Meter
indicates:
Summary of Contents for Ransomes CT435
