Textron Ransomes CT435, Operator Instructions Manual

Page: 24 / 76

22
OPERATION
Single Spool
Double Spool
Figure 32 - Operating Remote Control Valves
past detent position is a “FLOAT” position which
allows a cylinder to extend or retract freely.
NOTE: The lever of the single spool remote
control valve is shown in Figure 29. The tubing
coupler location for this valve option is shown in
Figure 30.
WARNING: Before disconnecting
cylinders or equipment, make certain
that the implement or equipment is
supported securely.
WARNING: Remote couplers must be
properly mounted and securely
fastened to tractor mounting bracket for
proper function of safety disconnect
feature.
OPERATING HYDRAULIC MANIFOLD BLOCK
The hydraulic Manifold Block is provided to supply
hydraulic oil to equipment such as a front loader,
dozer blade, etc. Location of the Block is shown in
Figure 33.
Figure 33 - Hydraulic Manifold Block
To operate auxiliary equipment, remove the plugs
from the manifold block and connect the feed hose
to the outlet port, Figure 33 and the return hose to
the inlet port.
IMPORTANT: In order to operate auxiliary
equipment, the control screw must be turned to the
position at (2). With a front remote valve installed,
it is not required to turn the control screw to the
position shown at (1) to operate the three point
linkage. When it is required to operate the three
point linkage only, the screw must be turned to the
position shown at (1).
DRIVING THE TRACTOR
WARNING: Observe the following
precautions when driving the tractor.
• Watch where you are going - especially at row
ends, on roads, and around trees.
• Keep the tractor in gear when going down hill.
Use a low gear to maintain control with
minimum braking.
• If the tractor is stuck, back out to prevent
upsetting the unit.
• Always use the drawbar for pull-type work. Do
not pull from any other part of the tractor
since it may tip backward.
2
1